Cheetah Mounts APTMM2B Flat Screen TV Wall Mount Bracket, uses Universal Tilt Mount 32-55″ – Plasma, LED, LCD TV Wall Mounts Mounting Brackets

Posted by admin in LCD and Plasma TVs on 04 17th, 2010 | 5 Comments

  • Universal Desing Fit most 32″ to 60″ TV Plasma, LED, LCD
  • Tilt: 0/15 Degree
  • Load Capacity; 165Lbs
  • Limited Lifetime Warranty
  • Vesa Compliant 100/200/400/400/600

Product Description
The Cheetah Mounts APTMMB Tilt Wall Mount offers a 0-15 degrees of tilt while maintaining a slim 1.9″ profile in the flat position. Weight capacity 160lbs supports hole patterns up to 28″ (711mm) wide by 19″ (483mm) tall. The universal design fits virtually any 32-55″ plasma or LCD TV…. More >>

Cheetah Mounts APTMM2B Flat Screen TV Wall Mount Bracket, uses Universal Tilt Mount 32-55″ – Plasma, LED, LCD TV Wall Mounts Mounting Brackets


Tags: , , , , , , , , , , , , , ,

5 Responses to “Cheetah Mounts APTMM2B Flat Screen TV Wall Mount Bracket, uses Universal Tilt Mount 32-55″ – Plasma, LED, LCD TV Wall Mounts Mounting Brackets”

  • Jack Hammer, on April 17th, 2010 at 3:02 pm Said:

    I purchased this online for approximately 17.00 plus shipping. My address was a Box number and shipping didn’t specify cannot ship to Box numbers. I think this is important because it takes a little work to locate a contact number, After a long period of waiting I receive a credit for 17.00 plus shipping. I call and the person said we don’t ship to Box numbers. It took two or three weeks to find this out by credit issue that I wasn’t going to receive it. I called the company and explained that UPS leaves a card at the box and I can pick it up at their station. They said you can order it again. I went to place a second order and the price changes to 23.69? So what was the reason not shipping again? Customer service is questionable so I wouldn’t recommend this company if you really need something in short order. If you have time to play the waiting game with a 50 50 chance then by all means do so. I did find a the same thing for less at that E auction place under buy it now.
    Rating: 1 / 5

  • D. M. Bussiere, on April 17th, 2010 at 5:18 pm Said:

    Have not used yet, but looks solid. Sure it will work out just fine! Fast Shipping
    Rating: 5 / 5

  • John Kerns, on April 17th, 2010 at 5:21 pm Said:

    You must set tilt BEFORE hanging. To change tilt you have to remove the TV from the wall!

    Even though they provide a torpedo level, it is off significantly. The mounts are thin, lightweight, compared to competitor’s mounts. I doubt they could hold the 165 pounds listed.
    Rating: 1 / 5

  • Victor J. Astraitis, on April 17th, 2010 at 5:50 pm Said:

    The issue with these brackets on an LG set is that the mounting brackets –when centered behind TV — extend down oyer the AV input jacks. So your options are to put the brckets higher on the set — which causes the brcekst to extend up over the tv and look unsightly — or not use any other component with the tv,
    Rating: 1 / 5

  • C. Corley, on April 17th, 2010 at 7:51 pm Said:

    The price on this TV wall mount was too good to pass up, but it is not very sturdy! This mount is barley capable of supporting a 50″ plasma. I am using it now for 4 months, but I worried about it the 1st week. So far it is still holding.
    Rating: 3 / 5

Leave a Reply